Vicon SURVEYOR 2000 7003-00, Installation & Operation Manual

Page: 49 / 64

Operation
Following the complete installation and setup of the Surveyor2000, it is necessary to perform initial power-up
testing and verify proper operation. If the Surveyor2000 fails to power-up correctly, go to the Troubleshooting
sub-section of this section. When initial power-up has been completed and verified, Surveyor2000 can be
setup and operated in a normal fashion using a Vicon remote operator keypad, VPS/NOVA unit or through a
PC running ProTech

software.
Initial Power-Up
Figure 33
Power-Up Test Screen
1. Setup an appropriate monitor within the
vicinity of the Surveyor2000. Connect the
video out cable to the monitor. Power-on
the monitor and verify that no signal is
displayed.
2. Verify that the Surveyor2000 has been
installed, wired and configured in
accordance with this manual.
3. Switch the AC power on to the
Surveyor2000. The monitor will display the
power-up test screen (Figure 33) for the
duration of its initial testing. This test
displays the status of the functions pan, tilt,
zoom, focus and the integrity of the
memory (NVRAM). If any test fails, “FAIL”
displays in place of “OK.”
4. Upon completion of these tests, the
camera drive moves slightly to find its
home position. It pans a few degrees and
returns to its original pan position, then tilts
a few degrees and finds its original tilt
position.
Figure 34
Opening Screen
5. The Surveyor2000 then switches to the
opening screen (Figure 34). This screen
will display the camera dome program
version, current date/time and some of the
current DIP switch settings. Upon
completion of homing, the Surveyor2000 is
ready to verify proper operation. (Note:
Figure 34 is only a sample screen.)
NOTE: The camera drive always returns to the
pan and tilt coordinates it was initially
powered-up with.
XX031-01 Rev 803 Surveyor2000 Camera Dome System Operation
•
45