Vicon SURVEYOR 2000 7003-00, Installation & Operation Manual

Page: 17 / 64

6. With the camera drive hanging from the enclosure, terminate all the cables as follows:
a) Remove terminal blocks TB1 and/or TB3. Since the control signals exist in both TB3 and J3, do not
remove TB3 if J3 will be used for control signal wiring.
b) Strip approximately 1 inch (25 mm) of insulation off all wires to be terminated in terminal blocks. Then
strip approximately 0.25 inches (6 mm) of insulation off of each individual wire.
c) Make all connections to terminal blocks TB1 and TB3 with reference to Table 2. On TB3, the
COMMAND IN + (CI+) and COMMAND IN - (CI-) connections must be used for Simplex operation.
For Half Duplex operation, the additional signals RESPONSE OUT + (RO+) and RESPONSE OUT -
(RO-) must also be used. Insert each wire into its proper terminal block location and tighten each
screw.
) Terminate the video (coaxial) cable with a BNC type male connector. d
Terminate the 8-conductor alarm
connectors J2 and J3 will be used. e) cable or control/relay cable with an RJ-45 male connector, if
WARNING : with control signals, as this will cause If Vicoax mode is being used, DO NOT wire TB3 or J3
the camera dome program to lock up upon power-up.
Reinstall the te 7. rminal blocks TB1 and TB3 into the Communication Power Supply Board at the proper
block frames.
8.
(for coax installations) or connect twisted-pair video wires to screw terminal TB4
(for UTP installations).
9. les should
be just long enough to reach their respective connectors or approximately 8 inches (203 mm).
Install the video BNC cable connector to the Communication Power Supply Board’s mating BNC
connector at location J1
Plug in all RJ-45 cable connectors to their corresponding mating connectors J2 and J3. All cab
WARNING : g connectors can cause damage Failure to insert the RJ-45 connectors into the correct matin
to the Communication Power Supply Board upon power-up.
10. Configure the Surveyor2000 communication and address DIP switches as follows:
a)
. le 3. All
or NTSC/ON).
5. Set switch 4 on DIP switch 2 (S2) to the appropriate communication protocol (RS-422 or RS-
485).
If RS-422 mode will be used:
Set switches 1 - 8 on DIP switch 1 (S1) to Surveyor2000’s address as specified in Tab 1
addresses between 0 and 255 are valid (address 0 is the same as camera number 256).
2. Set switch 1 on DIP switch 2 (S2) to the appropriate video mode (PAL/OFF
3. Set switch 2 on DIP switch 2 (S2) to the OFF position (VPS/NOVA mode).
4. Set switch 3 on DIP switch 2 (S2) to the OFF position (SIMPLEX/DUPLEX mode).
XX031-01 Rev 803 Surveyor2000 Camera Dome System Installation
•
13