Vicon SURVEYOR 2000 7003-00, Installation & Operation Manual

Page: 22 / 64

3. Set switch 2 on DIP switch 2 (S2) to the OFF position (VPS/NOVA mode).
4. Set switch 3 on DIP switch 2 (S2) to the appropriate communication mode (SIMPLEX/DUPLEX).
5. Set switch 4 on DIP switch 2 (S2) to the appropriate communication protocol (RS-422 or RS-
485).
b) If Vicoax mode will be used:
1. Set switch 1 on DIP switch 2 (S2) to the appropriate video mode (PAL or NTSC).
2. Set switch 2 on DIP switch 2 (S2) to the ON position (Vicoax mode).
3. Set switch 3 on DIP switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
4. Set switch 4 on DIP switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
NOTE : DIP switches labeled ON or CLOSED and OFF or OPEN have the same meaning.
10. Lift the lower dome up to the Surveyor2000
and line up the molded tabs on the lower dome
with the recesses on the inner enclosure.
There are only 2 ways to align it. Refer to
Figure 10.
Figure 10
Final Assembly, Ceiling Mount Version
11. Insert the plug on the safety cord into the hole
on the Surveyor2000. Push the lower dome up
into the Surveyor 2000. Verify that it snaps into
place on both sides. The upper edge of the
lower dome should be flush with ceiling plane.
12. Proceed to the Operation section of this
manual.
18
•
Installation XX031-01 Rev 803 Surveyor2000 Camera Dome System