Vicon SURVEYOR 2000 7003-00, Installation & Operation Manual

Page: 29 / 64

4. Set switch 3 on DIP switch 2 (S2) to the OFF position (SIMPLEX/DUPLEX).
5. Set switch 4 on DIP switch 2 (S2) to the appropriate communication protocol (RS-422 or RS-
485).
b) If Vicoax mode will be used:
et switch 1 on DIP switch 2 (S2) to the appropriate video mode (PAL or
. Set switch 2 on DIP switch 2 (S2) to the ON position (Vicoax mode).
. Set switches 3 and 4 on DIP switch 2 (S2) to either position, as they do
NOTE : DIP switches labeled ON or CLOSED and OFF or OPEN have the same
1. S
a
b
c
d
e
Pendant Mount
Figure 17
Final Assembly
NTSC).
2
3
not affect Vicoax protocol operation.
meaning.
h the Surve 15. Wit yor2000 hanging from the housing, verify that the wiring resembles
the technique of Figure 17a.
WARNING : Cables having excessive slack can cause damage to the
Surveyor2000 when installed into the housing.
urveyor2000 oriented as shown in Figure 17b, 16. With the S lift it so that it is flush
7. Turn the Surveyor2000 counterclockwise (looking up) until the arrow on the
8. Push the Surveyor2000 straight up into the housing as shown in Figures 17d and
9. Lift the lower dome up to the Surveyor2000 and press in its safety cord plug into
e, line
1. Tighten the 4 trim ring screws
2. Proceed to the Operation
with the housing.
1
Installation Label is aligned with the arrow on the inside of the housing as shown
in Figures 17b and 17c.
1
17e. Verify that the 2 slots on the Surveyor2000 snap into the housing clips. Do
not use excessive force. In the event that it does not snap easily, remove the
Surveyor2000 and verify proper cabling.
1
the hole provided on the inside of the enclosure to anchor the lower dome.
20. Holding the lower dom
Figure 18
Outdoor Lo Installation wer Dome
up the 2 molded tabs on the
lower dome with the 2
recesses on the inner
enclosure. There are only 2
ways to align it. Push the lower
dome up and verify that it
snaps into place on both sides.
See Figure 18.
2
to hold the lower dome in
place. Verify proper orientation
of the grommet.
2
section of this manual.
XX031-01 Rev 803 Surveyor2000 Camera Dome System Installation
•
25