Vicon RV 1601, Operation Manual

Page: 37 / 108

Chapter 6
G0201WAD3EN 35
electronic control system AUTOFORM
5
Confirm pushing button (the value stops blinking).
6
Pushing button you leave this function.
Attention:
The number of wraps does not depend upon the bale
diameter. At the start of wrapping the control system
automatically calculates the quantity taking into ac-
count the actual bale diameter. Only the pto speed
influences the real number of wraps: it is based upon
a pto speed of 540 rpm.
The twine tie programme P4 (flax programme) can be set
as desired as well.
Adjustable is:
-
Distance of the side wraps to the side of the bale in cm
(1 cm = 25/64"), shown at the rh in the display;
- Distance between the wraps when baling;
- Number of final wraps when bale has reached its final
diameter (center of the display);
- Wrapping pattern (left side of display).
Attention:
Flax twine tie programme only can work when elec-
tronic twine running sensors are installed and con-
nected!
Procedure:
1
Push .
2
Four times push button to move to twine tie pro-
gramme P4.
3
Select value to change by pushing -button, value
will blink.
4
Change value by pushing buttons and .
5
Confirm new value by pushing button .
6.4.8 Changing number of net wraps around
the bale
1
Push button .
2
Select net wrap by button if still required.
3
Push button to go to wrapping programme P5.
The value below the left picture (fig d18) indicates the
number of wraps.
4
Push button till that figure starts blinking.
5
Change value by pushing buttons or to desired
extend.
6
Confirm by pushing .
d18
d17