Communications (PTZ control) for the Kollector Strike/Basic
Connect as follows:
To connect a PTZ camera control to the Kollector Strike:
1. Using a twisted-pair cable as defined in
Chapter 9, Twisted-Pair Cable Recommendations
, prepare a
4-conductor plus shield type cable by stripping the ends back for use.
2. Connect the PTZ wires to the terminal block connector (while it is disconnected from the Kollector).
3. Connect the terminal block connector to the Tx/Rx connections on the rear panel. Ensure that you
connect the wires to the correct polarity or PTZ will not function.
Figure 3-6B: Kollector Strike PTZ Connector
4. Install the other end of this cable into the device it will communicate with; for example, a Camera Dome or
other type of receiver. Refer to Figure 3-7.
Figure 3-7: Kollector Strike/Basic PTZ Connection
XX112-06-01 Rev 911 Kollector Network Digital Video Recorders
Installation
•
17
