Vicon Cruiser SN660V, Installation And Operation Manual

Page: 20 / 86

14
3.6 Tour
(Shortcut: P70P )
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns,
Scans or other Tours (second-level). Using second-level Tours, there can be over 300 functions
in a single tour.
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : 5 STEP
DWELL : -- SEC
003 A04 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- P01 --- --- --- ---
--- T02 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- --- --- --- --- ---
SAVE AND EXIT(ESC TO CANCEL)
---
: blank position
SCAN TYPE : NORMAL, VECTOR
DWELL : 03 ~ 99 SEC
003 : Preset (1 ~ 240)
A04 : Auto Scan (1 ~ 8, 10 ~ 17)
P01 : Pattern (1 ~ 8)
T02 : Tour (1 ~ 8)
Follow the steps below to program the Tours:
1. Press the P95P key to display the main menu on the monitor. Scroll to Tour and push the
Joystick to the right to enter the Tour menu. Or just press the P70P key on the keyboard.
2. Select “ NUMBER ” and set the desired number by pushing the Joystick to the left or right.
3. Choose a blank position to be programmed by pushing the Joystick up, down, right, or left.
4. To add a stored Preset, twist the Joystick ; the stored Preset number displays.
5. To place functions other than preset, use the Joystick to move the cursor to a stored preset
position. Pressing the Open IRIS key will change the preset number to another function
(Auto Scan, Pattern, Tour or Preset) with the first programmed number. To change the
number, twist the
Joystick or press the ZOOM in or ZOOM Out key.
6. You can also overwrite the programmed number and remove a stored number from the Tour.
Press the Open IRIS key on the stored number; a blank position mark (---) will be displayed.
7. Repeat step 2 through 6 for each desired position. Each title will be displayed on top of the line.
8. To edit the “ TITLE ”, follow the procedure of the Auto Scan, above, to edit titles.
9. Select “ SAVE AND EXIT ” and push the Joystick to the right or press the Open IRIS key.
Press the Close IRIS key to exit the program without saving.
You can expand the Tour sequence by calling other programmed Tours.
NOTE: The speed applies in Vector mode only.
NOTE: In Tour mode, in conjunction with Preset and Auto Scan, you can make the camera travel
from a Preset position to another Preset position at a specific speed.