2.8 Enter this dimension into the display unit.
Third black highlighted box with ? mark.
2.9 Press the “OK” button on the right-hand key pad to
accept the value.
Black highlight will move to the next box with ?
mark.
2.10 Measure the distance from the movable front feet to
rear feet to the nearest
1
⁄
8
".
Center of bolt to center of bolt.
2.11 Enter this dimension into the display unit.
Fourth black highlighted box with ? mark.
2.12 Press the “OK” button on the right-hand keypad to
accept the value.
Black highlight will move to the Measure icon in
the lower right corner of the display.
3. SET MACHINE RPM IN TOLERANCE
TABLE
3.1 Use the left arrow button on the right hand key pad
to move the black highlight to the Tools icon. Press
the “OK” button to select.
3.2. Use the up arrow button to move the black highlight
to the tolerance table. Press the “OK” button to select.
3.3. Select the machine RPM using up/down arrow
buttons to highlight the correct RPM. Press the
“OK” button to select.
Use next highest RPM setting if machine RPM is
in between values listed.
3.4 Use the down arrow button to move the black
C H A P T E R 2
9
