Viavi SPA06MA, User Manual, Page: 103 / 412

Chapter 5 Using LTE/LTE-A FDD Analyzer
Conducting RF measurement
SPA06MA-O User’s Guide
April 2021 22145360, R005 Page 87
Setting measure setup
After configuring the spectrum measurement in “Configuring spectrum measurements”
on page 9 , you can set the measure setup to continue your measurement.
To set measure setup
1 Tap the Setup ( ) icon in the side bar.
2 Tap Bandwidth and select the value from the following choices: 1.4 MHz , 3 MHz ,
5 MHz , 10 MHz , 15 MHz , or 20 MHz .
You can also tap the rectangle with value,( ) under
the chart screen and input the value using the on-screen keyboard.
3 Tap the Center Frequency ( )icon under the chart
screen to set the center frequency using the on-screen keyboard.
4 Tap Menu > BW/AVG > Average to set the number of measurements to be aver -
aged using the on-screen keyboard.The input value range is from 1 to 100.
To set limit
1 Tap Menu > Limit .
2 Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica -
tion.
The result table color for Pass is green, and the result table color for Fail is red.
3 Tap High Limit to set the upper threshold using the on-screen keyboard.
4 Tap Low Limit to set the lower threshold using the on-screen keyboard.
5 Optional : Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement mode.
Figure 39 shows an example of LTE/LTE-A FDD channel power measurement.