Viavi SPA06MA, User Manual, Page: 362 / 412

Chapter 9 Using 5G DSS Signal Analyzer
Conducting OTA measurement
SPA06MA-O User’s Guide
Page 346 22145360, R005 April 2021
to EQP menu in JDMapCreator. For more information on how to use the JDMapCreator,
see the JDMapCreator 2.0 User Guide .
To log data
1 Follow step 1 to 3 in Setting measure setup.
2 Tap the Testing ( )button on the right panel of the map to start plotting on the
map. When you select a point on the map, a marker appears and the Information
window appears on the right panel.
3 Tap the Stop ( ) button to stop plotting.
4 Tap the Pause button ( ) to pause plotting, then the GPS point cannot be
plotted.
5 If you start test and select Setup > Map Config > Plot Point > Position , you can
undo by tapping the Testing button.
6 If you select the Stop button, the Plot Stop pop-up window appears, then tap Yes .
7 Tap Yes when the Save pop-up window appears and the logging file to your USB.
Viewing the logging data
To view the logging data
1 Load the saved logging file using the Load ( ) icon on the side bar. Make sure
the file extension is.gomv.
2 If the PCI is set to Auto , the point on the map appears with a color representing
the largest S-SS-RSRP value. When you select a point on the map, a marker
appears and the Information window appears on the right panel.
3 Set the PCI to Manual and tap the Select button.
The Select PCI window appears.
4 Select PCI on the left and then the corresponding Beam Index appeared on the
right.
5 Tap the Apply button.
The point color of the map changes to the corresponding SS-RSRP value, and if
there is no detected Beam Index, the point will be hidden.
Importing cellsite DB
You can import the site DB by creating the 5G site information form.
To import cellsite DB
1 Create the 5G site information with an excel file as below.
2 Input the two mandatory fields: Lat (DecDeg) and Long (DecDeg) .