vetus®
Installation instructions BOW PRO Series Thrusters: BOWA0361, BOWA0364 and BOWA0421
30
020803.05
6 .7 Configuring a panel for operating a bow thrust-
er or a stern thruster
1 x
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the On / Off button once to switch the panel
to the OFF position.
1 Place the panel in configuration mode
• Press and hold the On / Off button for 10 seconds.
BLUE
RED
1 x
1 x
2 Push the joystick to the left.
didahdi ( . − . )
3 Keep the joystick in this position and press
the On/Off button.
During the first 6 seconds, the buzzer will continuously signal a didi-
didididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -). Now the panel is in
configuration mode.
4 Release the joystick after the signal didahdi
( . – . ) is given.
5 Configuring for a bow thruster: Push the joystick to the left once.
Configuring for a stern thruster: Push the joystick to the right once.
6 Press the On/Off button once to confirm
the setting.
10 seconds
seconds
Configuration mode
seconds
6
dididididididid ( . . . . . . )
dididididah ( . . . . − )
4
2
3
4
5
6
1
Carry out the following actions on EACH panel in the order indi-
cated:
n
ote
With a bow and stern thruster panel, together at the same helm
station, the helm station number entered must be the same .
BPPPA
BPPJA
ON/OFF
ON/OFF
n
ote
Settings are retained even if the supply voltage is switched
off!
OR
