English - 78 -
by pressing the
OK
to continue with the
reboot operation.
3 AM search and upgrade mode
Your TV will search for new upgrades at 3:00
o’clock if
Automatic scanning
option in the
Upgrade options
menu is set to
Enabled
and if the TV is connected to an aerial signal
or to Internet. If a new software is found and
downloaded successfully, it will be installed at
the next power on.
NOTE:
Do not unplug the power cord while
led is blinking during the reboot process. If the
TV fails to come on after the upgrade, unplug,
wait for two minutes then plug it back in.
J
J
Connectivity
Wired Connectivity
To Connect to a Wired Network
•
You must have a modem/router connected
to an active broadband connection.
•
Connect your TV to your modem/router
via an ethernet cable. There is a LAN port
at the rear (back) of your TV.
Broadband ISP connection
LAN (ethernet) cable
LAN input on the rear side of the TV
To configure wired settings please refer to
the Network/Internet Settings section in
the
System>Settings Menu.
•
You might be able to connect your TV to
your LAN depending on your network’s
configuration. In such a case, use an ethernet
cable to connect your TV directly to the
network wall outlet.
LAN input on the rear side of the TV
network
wall socket
Configuring Wired Device Settings
Network Type
The
Network Type
can be selected as
Wired
Device,
Wireless Device
or
Disabled
, in
accordance with the active connection to the
TV set. Select this as
Wired Device
if you are
connecting via an ethernet cable.
Internet Speed Test
Highlight
Internet Speed Test
and press
the
OK
button. TV will check the internet
connection bandwidth and display the result
when complete.
Advanced Settings
Highlight
Advanced
Settings
and press the
OK
button. On the next screen you can
change the IP and DNS settings of the TV.
Highlight the desired one and press Left
or Right button to change the setting from
Automatic
to
Manual
. Now you can enter
the
Manual IP
and / or
Manual DNS
values.
Select the related item in the drop down menu
and enter the new values using the numeric
buttons of the remote. Press the
OK
button
to save settings when complete.
