VESPA LX 50, Workshop Manual

Page: 66 / 160

Stationary driven half-pulley/Standard diame-
ter
Ø 33.965 to 33.985 mm
Stationary driven half-pulley / Minimum diam-
eter admitted after use
Ø 33.96 mm
Inspecting the driven sliding half-pulley
- Remove the 2 inner sealing rings and the two O-
rings.
- Measure the inside diameter of the mobile half-
pulley bushing.
Characteristic
Mobile driven half-pulley/ Maximum diameter
allowed
Ø 34.08 mm
- Check the belt contact surfaces.
- Insert the new oil seal and O-rings on the mobile
half-pulley.
- Fitting the half-pulley on the bushing.
Recommended products
AGIP GREASE SM 2 Grease for the C-ring of
the tone wheel
Soap-based lithium grease containing NLGI 2 Mo-
lybdenum disulphide; ISO-L-XBCHB2, DIN
KF2K-20
- Make sure the pins and collar are not worn, reassemble the pins and collar.
- Use a greaser with a curved spout to lubricate the driven pulley unit with around 6 g of grease. This
operation must be done through one of the holes inside the bushing until grease comes out of the
opposite hole. This procedure is necessary to prevent the presence of grease beyond the O-ring.
Recommended products
AGIP GREASE SM 2 Grease for the C-ring of the tone wheel
Soap-based lithium grease containing NLGI 2 Molybdenum disulphide; ISO-L-XBCHB2, DIN KF2K-20
Engine
Vespa LX 50
ENG - 66