VESPA GTS Super 125 i.e., Service Station Manual

Page: 194 / 285

- Refit the fifth wheel fitting and the dust gaiter on
the steering bearing until they stop, using the spe-
cific tool.
Specific tooling
006029Y Punch for fitting steering bearing seat
on steering tube
- Use the specific tool to fit the fifth wheel fitting on
the headstock as indicated in the figure
Specific tooling
001330Y Tool for fitting steering seats
- Remove the steering tube
- Remove the attachment bracket
- Use the specific tool with the part 1 and operate
the handgrip until removing temporarily the pin and
the Nadella opposite the tool thrusting direction.
- To extract the second Nadella, use the tool with
the part 2, instead of part 1, on opposite side to the
one indicated in the figure.
Specific tooling
020021Y Front suspension service tool
- Fit both dust guard rings «C» on the swinging hub
as shown in the detail drawing «A» .
- Connect the swinging hub to the steering tube
with the guiding pin, part 5.
- Use the specific tool fitted with part 3 on the stem
and part 4 on the tool base.
- Lubricate the pin with recommended grease and
insert it temporarily on the swinging hub, move the
tool handgrip until part 3 is fully inserted on the
steering tube.
Suspensions
Vespa GTS Super 125 i.e.
SUSP - 194