System Timers I - III (PGM 180, 181,182)
2-79
Chapter 2: SBX IP Offline PCAdminPro
SBX IP - PC Admin Guide
System Timers - II (PGM 181)
ITEM
RANGE
DEFAULT
REMARK
Call Forward No Answer
Timer
000-255
(3 digits)
015
(sec)
The Call forward busy/no answer feature will take place
using this timer. If this timer has a non-zero value and an
extension is set to busy, no answer forward by the station
user, then the extension will ring for this timer and will then
forward to the next destination.
DID/DISA No Answer
Timer
00-99
(2 digits)
25
(sec)
A DID call will be forwarded to the Attendant if the station
is busy or does not answer within this time.
VMIB User Record Timer
010-255
(3 digits)
020
(sec)
The time duration of the VMIB user greeting.
VMIB Valid User Message
Timer
0-9
(1 digit)
4
(sec)
The time duration of a valid VMIB user message.
Door Open Timer
05-99
(2 digits)
20
(100ms)
This timer establishes the length of time that is needed to
activate a door open relay.
ICM Box Timer
(Doorbox)
00-60
(2 digits)
30
(sec)
Establishes the amount of time programmed stations will
ring when the ICM box user presses the [CALL] button.
ICM Dial Tone Timer
01-20
(2 digits)
10
(sec)
If action is not taken within ICM dial tone timer, the user
will receive an error-tone.
Inter Digit Timer
01-20
(2 digits)
05
(sec)
If the time between dialed digits exceeds the Inter-digit
timer, the user will receive an error-tone.
MSG Wait Reminder Tone
Timer
00-60
(2 digits)
00
(min)
Establishes the amount of time between repeated
reminder tones to a key telephone with a message
waiting.
Paging Timeout Timer
000-255
(3 digits)
015
(sec)
Establishes the maximum time allowed for a page. The
system will automatically disconnect the page at the end
of this time unless the caller has hung up earlier.
Pause Timer
1-9
(1 digit)
3
(sec)
Establishes the length of the pause for use with
automatically sent digits or other speed dialing.
Preset Call Forward Timer
00-99
(2 digits)
10
(sec)
Establishes the amount of time an outside line call will ring
before being forwarded to a predetermined station. This
entry works with Preset Forward Assignments in station
attributes. More than one station can be forwarded to the
same destination.
Release 3.5
June 2010