FT-950
Operating Manual
Vertex Standard Co., Ltd.
19
pseudo-straight-key operation.
Note: You cannot use a 2-contact plug in this jack (to do so produces a constant “key
down” condition).
18. [MONI] Knob
This knob adjusts the audio level of the transmit RF monitor during transmission
(relative to the [AF GAIN] knob), when activated by the [MONI] button.
19. [SQL] Knob
This knob sets the signal level threshold which at the receiver audio is muted, in all
modes. It is very useful during local rag-chews, to eliminate noise between incoming
transmissions. This control is normally kept fully counter-clockwise (off), except when
scanning and during FM operation.
20. [SHIFT] Switch
Pressing this button allows you to adjust the IF DSP bandwidth using the [SELECT]
knob. While activated, the LED inside this button glows orange.
21. [WIDTH] Switch
Pressing this button allows you to adjust the overall bandwidth of the IF DSP filter
using the [SELECT] knob. While activated, the LED inside this button glows orange.
22. [CONT] Switch
Pressing this button allows you to select the DSP Contour filter response using the
[SELECT] knob. While activated, the LED inside this button glows orange.
23. [NOTCH] Switch
Pressing this button allows you to adjust the center frequency of the IF Notch filter
using the [SELECT] knob. While activated, the LED inside this button glows orange.
24. [µ-TUNE] Switch
Pressing this button allows you to adjust the center frequency of the µ-Tuning filter
passband using the [SELECT] knob, when the optional RF µTuning Kit is connected.
While activated, the LED inside this button glows orange.
25. [CLEAR] Switch
