FT-950
Operating Manual
Vertex Standard Co., Ltd.
101
3. Rotate the [SUB VFO-B] knob to set this Menu item to “On” (the default setting is
“OFF”).
4. Press and hold in the [MENU] button for two seconds to save the new setting and
exit. Operation will now be restricted to the six Memory Groups.
To cancel Memory Group operation, repeat steps (1) through (4) above, choosing “OFF”
in step (3).
Advice: Note that for the PMS memory group, the PMS memories “P1L” through “P9U”
will be so designated, so as to avoid confusion.
Memory Channel Number
Group Memory “OFF”
Group Memory “ON”
01 ~ 19
1-01 ~ 1-19
20 ~ 39
2-01 ~ 2-20
40 ~ 59
3-01 ~ 3-20
60 ~ 79
4-01 ~ 4-20
80 ~ 99
5-01 ~ 5-20
P1L/P1U ~ P9L/P9U
P-1L/P-1U ~ P-9L/P-9U
US1 ~ US5
US-1 ~ US-5
Choosing the Desired Memory Group
You may recall memories just within a particular Memory Group, if desired.
1. Press the [V/M] button, if necessary, to enter the “Memory” mode.
Advice: If you can not enter the “Memory” mode, check to be sure that the
[VFO-B(RX)] Indicator/Switch is illuminated green. If it is, press the [VFO-A(RX)]
Indicator/Switch to make the [VFO-B(RX)] Indicator/Switch go out, then press the
[V/M] button again.
2. Press the [GRP] button (upper and to the right of the [CLAR/VFO-B] knob). The
imbedded LED inside the switch will glow orange.
3. Rotate the [CLAR/VFO-B] knob to select the desired Memory Group.
4. Press the [MCH] button (just below the [GRP] button). The imbedded LED inside
the switch will glow orange.
5. Rotate the [CLAR/VFO-B] knob to select the desired Memory Channel within the
Selected Memory Group.
Advice: If no channels have been assigned to a particular Memory Group, you will not
have access to that Group.
