FT-2000
Operating Manual
Vertex Standard Co., Ltd.
23
CONTOUR filter response. The CONTOUR filter is engaged via the [CONTOUR]
button.
DNR Knob
The outer [DNR] knob selects the optimum Main band (VFO-A) receiver’s Digital Noise
Reduction response. The Noise Reduction circuit is engaged via the [DNR] button.
61. RX Indicator/Switch
This is the button that turns the Sub (VFO-B) receiver On and Off. When this button is
pressed to make the Sub (VFO-B) receiver active, the Green LED imbedded within the
button will light up. Pressing the button again will disable this receiver, and the
imbedded Green LED will turn off.
62. TX Indicator/Switch
This is the button that turns the Sub (VFO-B) transmitter On and Off. When this
button is pressed to transfer transmitter control to the Sub (VFO-B) frequency and
mode, the Red LED imbedded within the button will light up. Pressing this button once
more will transfer frequency/mode control back to the Main (VFO-A) side, and the Red
LED imbedded within this button will turn off.
63. SUB VFO-B Knob
Depending on the status of the [A/B] button located at the right bottom of the [SUB
VFO-B] knob, the [SUB VFO-B] knob is used for functions associated with the Main
(VFO-A) or Sub (VFO-B) frequency control registers.
64. (VFO-A) BAND Switch
Pressing this button allows you to select the Main (VFO-A) operating band (Amateur
bands) using the [SUB VFO-B] knob.
65. (VFO-A) MHz Switch
Pressing this button allows you to tune the Main band (VFO-A) frequency down or up
in 1 MHz increments, using the [SUB VFO-B] knob.
66. GRP Switch
Pressing this button allows you to select the memory group using the [SUB VFO-B]
knob.
