
23 CUCINA 36P VERONA 07-2011 BOOKLET for HenryRev. o4
On Gas Oven Burner, adjust burner air shutter to the widest opening that will
not cause the flame to lift or blow off the burner when cold. In case of yellow
flame on burner, open burner air shutter making sure the flame does not lift or
blow off. In case of distinct blue flame but lifting, close burner air shutter to
the point where it will not cause a yellow flame, figure 16.
APPLIANCE PRESSURE REGULATOR CONVERSION
The unit appliance pressure regulator must be set to match the type gas
supply used. If converting from natural gas to LP gas, the appliance pressure
regulator must be converted to regulate LP gas. If converting from LP gas to
natural gas, the appliance pressure regulator must be converted to regulate
natural gas. To install the gas regulator you must you a CSA certified Pipe
Sealant only.
To convert the appliance pressure regulator from one gas to another; remove
the cap, push down and turn counter-clockwise. Turn the cap over and
reinstall, follow the NAT or LP indication (figure 17A and 17B), page 31.
NOTE:
THE GAS TYPE YOU ARE CONVERTING TO MUST BE
VISIBLE ON THE TOP OF THE INSTALLED APPLIANCE PRESSURE
REGULATOR CAP.
SERVICE
– PARTS INFORMATION
When your range requires service or replacement parts, contact your dealer
or authorised service agency. Please give the complete model and serial
number of the range which is located on the range model number plate.
LOW SETTING VALVE ADJUSTMENT
The LOW setting should produce a stable flame when turning the knob from
HIGH to LOW. The flame should be 1/8 inch or lower and must be stable on
all ports on LOW setting.
To adjust:
Operate burner on HIGH for about five minutes to preheat burner
itself. Turn knob back to LOW; remove knob, and insert a small flat tip
screwdriver into the centre of the valve stem. Adjust the flame size by turning
adjustment screw in either direction, while holding the stem (figure 18). For
Gas Oven adjustment remove knob and insert a small flat tip screwdriver on
left side slot (figure 19), page 31.