40
20306746
WDV See-thru Gas Fireplace
Using the Mounting Base
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
1. Secure the mounting base
on the wall with supplied
screws. For best viewing
angle, make it the same
height as your eyes.
2. Hang the transmitter on the
hook of the mounting base,
then push down so the
transmitter is flush to the
mounting base.
TROUBLESHOOTING
Figure 56
TOUCH SCREEN REMOTE CONTROL OPERATION
Symptom
Causes
Action
Battery icon on LCD on
transmitter
Low Battery
Replace batteries. Change batteries every
6 months.
LCD display is blank
Check battery installation or replace batteries.
LCD display shows
“funny" display
Reset the transmitter (see “Resetting the
Transmitter" section).
Appliance does not
come on
The transmitter did not match with the
receiver.
Make sure the transmitter has learned to the
receiver.
Transmitter measures temperature
exceeding 99°F and shows “HI" on LCD.
Move transmitter to a cooler place and wait
until temperature drops below 99°F degrees.
Distance between the transmitter and
receiver is more than 30 feet.
Make sure the opening distance is less than
30 feet.
Blower is not on after
the fireplace is turned
on
Blower setting is off.
Press FAN key to select Fan speed you
desire.
Blower delay setting is set too high.
Press and hold FAN key to set desired ON/
OFF delays. This is done in minutes.
