36
20306744
WDV Series Gas Fireplace
SIGNATURE COMMAND SYSTEM OPERATION
SETTING PRIVACY CODE ON
TRANSMITTER:
Figure 45
The remote transmitter privacy code is preset in factory.
In the event of activation or interference from other nearby
transmissions, change the code using the following
procedures (learn function must be
performed after changing the code):
1. Press the ON/arrow button and
the TIMER button at the same
time to enter privacy code setup
mode.
2. The setup display is shown in the
figure. The four digits on the top
stand for the privacy code (as the
actual DIP switches on Ambient’s
previous remotes). The default
values of the four digits will be all
“1” (ON).
3. The first digit will be flashing upon entering the setup
mode. Push the ON button to toggle its value between
“0” (OFF) and “1”(ON), and push the “OFF” button
to jump to the next digit. The next digit will then start
flashing and the first one stops flashing. Set up the
four digits to your choice.
4. After setting up all the four digits, push “OFF” to finish
the process and return to the previous mode.
5. The Signature Command control board then needs to
re-learn the new setting.
PERFORMING LEARN FUNCTION
1. The RF receiver button on the control board in the
fireplace must be in the on position before the learn
function can begin. With the Command Center master
switch in the ON position, use paper clip to depress the
recessed button on Control Board, one beep for RF
receiver ON or two beeps for RF receiver OFF.
Figure 46
2. Holding the OFF
button on the
Command Center
while turning on the
master switch will
activate the learn
function for the
transmitter.
3.
After the above
operation, two
beeps will be given
and the green LED
on the Command
Center will flash for
10 seconds.
4. During the 10 seconds, press the OFF button on the
transmitter to learn. Another two beeps will be given to
confirm a successful learning.
Figure 48
W
ARNING
Do not use two (2) or more remote control
systems in the same area with the same privacy
code setting, as they will communicate with
each other. This may cause the appliances to
malfunction.
FP2649
set privace code
Figure 45
FP2650
command ctr ctrl brd
RF Receiver
ON/OFF
Figure 46 -
Control Board
FP2650
command ctr ctrl brd
Battery Door
Master Switch
ON
LED
OFF
FP2650
Figure 47 -
Command Center
RESETTING THE TRANSMITTER:
If the transmitter is not working properly, reinstall the
batteries to reset the transmitter.
1. Pull out at least one of the batteries.
2. Press any key on the screen to discharge.
3. Wait for 10 seconds and reinstall the batteries.
Pushing and holding any key for more than 10 seconds
until the display refreshes will also reset the transmitter.
FUNCTIONS AND OPERATIONS
GENERAL
The TSFSC Remote Control has four (4) operating
modes: Manual, Timer, Thermostatic and Smart Mode
®
thermostat. The control system can be set to temperature
range between 45° F and 90° F. The blower speed and
flame height can be adjusted in the manual, timer and
thermostatic mode. The Smart Mode
®
thermostat will
automatically adjust flame height and blower speed
according to the difference between Set and Room
temperatures.
The transmitter will operate the remote receiver from 1
foot to a maximum of 30 feet. The distance is reduced
when batteries are low.
MANUAL MODE
Figure 48
In this mode, the TIMER button and the THERMO button
will only display “TIMER” and “THERMO”, respectively
without showing the time and the SET temperature.
Pressing the ON/up and OFF/down buttons will change
the flame height if none of the menu buttons (TIMER,
THERMO, LIGHT, FAN, AUX) are pressed and flashing.
Front Panel Bezel
Optional
