30
20303735
VWDV70 Series Gas Fireplace
GLass & stone pLaceMent
GLass anD stone pLaceMent
If you will be installing the optional accessory log set,
Model LKW70, install the two (2) rear logs
before
installing
the decorative colored glass. Refer to Accessory Log Set
Installation, Page 31.
Find the pre-molded 4-stone assembly. Place these stones
over the pilot assembly by aligning the holes in the bottom
of the stone assembly with the pins on either side of the
pilot assembly.
Figure 45
note:
The 4-stone assembly must be installed before any
decorative glass is installed.
Figure 44 -
Glass Placement
LG1100
VWDV70 glass
LG1100
cautIon:
Do not allow these stones to contact any part
of the pilot parts. Do not allow any of the pilot flames to
contact any stones. Do not allow stones to sit directly on
burner ports or in flames.
Place three (3) pieces of hearth glass lenses (supplied)
into opening on hearth in front of burner.
Unpack all decorative colored glass and stones included in
kit. Carefully mix the two colors of decorative glass. Place
the decorative colored glass above and outside the burner
to cover hearth area. Spread decorative glass in a single
layer.
Figure 44
cautIon:
Do not place decorative colored glass over the
open gap between burner and hearth as this will block the
air flow and affect the performance of
the unit. Keep decorative glass behind
bracket surrounding the burner and
hearth.
Find the four (4) large stones. Place
them along the rear wall approximately
equally spaced as shown in
Figure
46
.
Place the remaining stones randomly
outside the burner area over the hearth
and hearth glass all around the burner.
Figure 47
Turn burner on and adjust decorative
glass over the ported burner area to
achieve an even, clean flame.
Replace glass door frame.
Figure 45
LG1113
LG1113
4 pilot stones
Figure 46
LG1114
LG1114
4 large stones
