34. Status assigned from the washing machine.
Related information aboutthe device
will not be
displayed until it is connected from the
device to the system.
35. Status of the elevator controller.
You can enable/disable the elevator control function.
Note: This feature only works if an elevator control module is installed on the system.
36. Setting the security parameters of the input
unit (depending on the type).
37. Tampéru,
(protective contact when the cover is opened
illegally) after
activation of this function, a security
contact will be activated in the input station , tamp
é
r and if someone tampers with the entrance
station, an alarm
will be triggered. The room number must also be set to receive the tampee alarm.
38. Check the condition of the door.
If this function is enabled, the system checks the door status after the longest opening time
Door. Set "Magnetic Contact Type" according to door lock type
(Normally open or Normally closed). Set "Longest opening time". Once the door is open, the entrance
station will check their status for the longest opening time set.
If the door is not closed after the longest opening time set, a beep will sound from the entrance station.
39. Adjust the volume of the bell speaker.
You can adjust the volume from 10% to 100% as needed.
40.Adjust the angle of view.
You canset the angle of viewfor
the
entry station. Press the menu to set the angle ofview
from the
entry
station. Touch thelocationon the screen where it wants
to
get closer.
Press the tracking icon
to exit. Finally, tap the return icon in the upper-left corner of the screen and
press the confirm settings icon to save the settings. Whenitrings fromtheentrance station,
a set
image
appears.
41. Set a password to configure a door lock
The password can be up to 8 digits, the first digit must not be 0
42. Setup mode.
It is turned on by default. If enabled, you can set "Room Address" and "Floor" for monitors on the network.
If it is turned off at all entry stations
network, you will not be able to change the address of any monitor. If you don't want users to accidentally
change the address of your monitors, turn off this feature on all input stations after installation.
43.System settings
N.o
.
Settings
Items
Item
Explanation
1
Set up sound
Still
Ringtone Sound
Off by default. If enabled, the monitor will not
ring when it rings.
Repeat ringtone: If you turn off the monitor
when
ringing only once.
Door opening ringtone: Set the ringtone for
calls from vst. Station.
