9
Step 6: Tilting angle adjustment. Loose the nut M8 (No. 2B), and adjust the tilting
angle by hand. The angle is to be set up to 45 degree.
2B
Step 7: Finally, fasten the nut M8 (no. 2B) by hand and Phillips Screwdriver.
3. HOW TO OPERATE
1. Connect the device to the mains using the power cord;
2. The heating element will light up and starts heat;
3. Power off the device by unplugging the plug or a wall switch (sold and installed
separately)
Remark:
There may be a smell after switching on the device for the first time of following
long periods of non-use. This is normal.
Attention! Do not stare into the heating element for a long period.
4. CLEANING
l
Disconnect the appliance from the power supply system;
l
After the appliance has cooled down, the housing can be wiped dry;
l
Do not touch the heating element with your fingers, since stains could build up
from such a contact.
l
Do not use any abrasive or caustic cleaning agents!
l
Never immerse the appliance in water! Danger to life!
5. MAINTENANCE
Any maintenance or repairs including replacing the heating element should only be
carried out by a qualified electrician.
The heater should be plugged in to the supply mains with an all-pole
disconnection mechanism with a breaker. The all-pole disconnection mechanism
must be installed on the height less than 1.8m from the floor.
