10
6. SPECIFICATION
MODEL
VALSH2000
VALSH3000
Voltage
240V
~
50Hz
240V
~
50Hz
Rated power (W)
2000
3000
Mounting height (M)
1
.
8
1
.
8
Electric protection class
I
I
Water splash proof rate
IP65
IP65
Unit size L*W*H (MM)
660
*
88
*
133
1115
*
88
*
133
7. TROUBLESHOOTING
Possible malfunctions are given in Table below. (Ventair’s detail see next page)
SYMPTOM
CAUSE
Will not heat
/
No operation indicator
Check that power is connected and switched on, if still faulty, turn
off the heater, and contact manufacturer for advice or your
installing electrician.
This is caused by oil or dust left over from the manufacturing
process and will stop after a short time.
This is normal and should stop after a short time.
Build up of debris and dust on the heater, switch the heater off and
allow it to cool down and then clean.
Turn off the heater, and contact manufacturer.
This is expansion and contaction noises of the heaters metal
component and is normal.
Turn off the heater, and contact your manufacturer for advice or
your installing electrician.
Exposure to extreme ambient conditions such as high winds/
excessively cold temperatures can lower the heating performance
of an outdoor installation.
Unit is nor installed in correct pisition, possibly too high or heater
is too small for recommended area.
Poor heating performance
When associated circuit breaker (safety
ground) is thrown or a fuse is blown
Clinking noises when heater is turned
on and after being turned off
This is a burning smell and or stange
sounds (other than normal expansion
and contraction noises) coming from
the unit
Heater smells when turned on after
periods of no use
Heater smells when first used
Faint smell for short periods after
turning on the heater
