Vendo V21, User Manual

Page: 27 / 93

G-7
Part #1169256 09/2008
V21 PRODUCT SETUP AND LOADING INSTRUCTIONS
1
FOLLOW THE 3 STEPS BELOW WHEN SETTING VENDOR UP FOR A PRODUCT
BACK SPACER
Adjust the back spacer to provide approx. 1/4" to 1/2" gap
between the front spacer, product and back spacer.
2
PRODUCT STEP
For short product vending, move the product step
to the "FORWARD" position.
For tall product vending, move the product step
to the "BACK" position.
3
DEPTH SETTING (ELECTRONIC CONTROL MODE)
The "DEPTH SETTING" for each column must correspond to the number of products in the column.
For example; the depth setting for a column vending double depth bottles must be set to "2", and
a column set to vend quadruple depth cans must be set to "4".
Refer to the VEC 12 programming instructions for details on how to access and change the depth setting mode.
"FORWARD"
FOR
SHORT PRODUCT
"BACK"
FOR
TALL PRODUCT
1124035
1/4" TO 1/2" GAP
FRONT
REAR
FRONT SPACER/RETAINER
BACK SPACER
SHORT PRODUCT = LESS THAN 7.0" TALL (PRODUCT STEP FORWARD)
TALL PRODUCT = MORE THAN 7.0" TALL (PRODUCT STEP BACK)
SMALL DIAMETER PRODUCT SETTING
Small diameter products (less than 2.5" Ø) such as 500 ML water bottles require the use of side spacer PN 1122928.
2.5" Ø OR LESS
Small diameter 250 ML energy drink cans (2.1" Ø) require the use of conversion kit PN 1121638.
For questions regarding product settings, contact the Vendo Technical Services Department at
1-800-344-7216 ext.3368 (US/Canada) or 559-439-1770 ext.3368.
2.1" Ø
Vend mechanism is self priming. No need to manually prime after initial load or reload.
PRODUCT LOADING
Double depth bottles may be loaded with
caps toward the back, or butt to butt.
Triple depth bottles must be loaded
with caps toward the back.
F
R
O
N
T
O
F
V
E
N
D
O
R
2D
2D
3D
MIN. PRODUCT HEIGHT
4 Deep: Cans between 4.50" and 4.85" tall.
3 Deep: Bottles or cans between 4.85" and 6.50" tall.
2 Deep: Bottles between 6.50" and 9.95" tall.
1 Deep: Bottles taller than 9.95".
4D 3D 2D
Quadruple depth cans may be loaded
any direction.
Single depth bottles should be loaded
with cap toward the back.
1D
4D
NOTES
Side spacers ARE NOT required for 12 oz. can vending.
FIGURE 6