For your Safety
1. Please read this manual carefully before attempting the assembly or installation of your new ceiling fan.
2. ALL electrical work, including installation of ceiling fan, MUST be carried out by qualified and licensed
electrical contractor.
3. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning the safe use of the appliance, by a person responsible for their safety.
4. Do NOT allow children to play with this appliance, and supervise children around electrical devises at all
times.
5. Before commencing any electrical work, ensure the power is disconnected and/or the mains switched off
at the circuit box and ensure all pole isolation of the power supply.
6. Ensure that any fan being installed has an isolation switch in same room as fan. If multiple fans being
installed in same room, an isolation switch is required for each ceiling fan.
7. The fixing point for your ceiling fan must be of sound construction, undamaged, and capable of supporting
a load of 40Kg, or 5 times the weight of the fan plus the method of attachment, whichever is greater.
Verifying the stability of the mounting structure is the sole responsibility of the consumer and qualified
installer.
8. Care needs to be taken to ensure the installation location does not allow the fan blades to come into
contact with any object or surface. There must be a minimum of 30cm clearance between the blade tip
(end) and the nearest wall or object. Reduced clearances to walls or ceilings can also reduce the amount
of air your fan can move.
9. The installation must also allow for a minimum clearance of 2.1m between the floor and the bottom of the
blades.
10. Both the ceiling fan and the hanging bracket must be earthed.
11. The fan must be connected to a mains supply only. Fans connected to alternate power systems such
as Solar, Wind, Battery or other alternative power methods, will not be covered under the terms of this
warranty.
12. Use ONLY the Vencha controller supplied with your fan. Use of non-standard or solid-state dimmer type
controllers can cause inferior performance, and permanently induce a humming noise in your fan motor
which cannot be repaired, and which will not be covered under warranty.
13. This fan is designed for indoor and covered outdoor use. Covered outdoor areas must have a minimum of
two walls.
14. Do not install fan in high humidity or flammable areas. Fan must be used in a dry area.
15. Do NOT use ceiling fans and gas appliances in the same room at the same time.
16. Do NOT insert any object into the fan blades whilst in operation, as this can cause damage to the fan,
and personal injury.
17. All Vencha products are warranted to be free from defects in workmanship and materials provided the
products are used with a voltage supply within the range the product is designed to operate.
18. Vencha will not be liable for any advice given to the consumer from any of our suppliers or third parties,
related or otherwise.
19. Proper performance relies on the right fan being correctly installed in the optimum location. Fans that do
not perform as expected and which are not faulty cannot be replaced or exchanged under warranty.
20. The important safeguards and instructions in this manual are not designed to cover every possible
condition or circumstance. It is understood that common sense, caution and care are factors that cannot
be built into the product, those using and maintaining this product must supply these factors.
Care and Maintenance
All fans need to be maintained regularly to ensure optimal performance. Maintenance includes light clean-
ing regularly to insure against corrosion from salt, dust and moisture. Checking of all screws and tightening
with a screw driver if any have come lose after operating.
It is recommended to clean with lint-free cloths to prevent any scratching of surfaces.
*Do note clean fan using harsh solvents containing erodible liquids such as gasoline or petroleum.
*Do not bend blades during installation, blades balancing or fan cleaning.
4
