VEMCO - VR2C Manual
9
Jul 2018
55
A desiccant pack has been included inside the VR2C to reduce the
occurrence of condensation inside the case. This pack should remain in
the receiver case during storage and deployment.
We recommend that you replace the desiccant pack with each battery
replacement cycle.
More information on the availability and usage of these packs is located on
our website, www.vemco.com.
Push the wires
away from the
edge of the case
so they won’t be
pinched in the
case and
damaged.
STEP 6
Coil the covered
wires into the case.
This helps the wires
to slide down the
case and not be
damaged when the
case is closed.
STEP 5
Turn the Receiver Locking
Ring with your hand until it
becomes too hard to turn.
STEP 8
Line up the keying
features of the upper
and lower housing
units and slide the
lower housing into the
upper housing while
being extremely careful
to avoid pinching the
wiring harness
between the upper and
lower housings.
STEP 7
Verify that the
Receiver
Locking Ring
covers the
O-ring on the
outside of the
upper housing.
STEP 10
Use the strap wrench in the VR2C Communication
Package to tighten the Receiver Locking Ring in
place.
STEP 9
