VEMCO - VR2C Manual
9
Jul 2018
52
5.2.2.3
Inserting or Replacing Battery
With the used battery removed from the VR2C case as described in section
5.2.2.2, follow the instructions listed below to install a new lithium battery
(see section 0 for battery model number).
The Battery Status must be reset every time the battery is replaced (see
section 5.2.2.6).
The Battery Status must
be
reset
every time the
battery is replaced (see
section 5.2.2.6).
Slide the new battery into the battery cup so the
battery connector wires are on the topside of the
battery.
STEP 1
Position the battery so
the battery wires are
close to the wires on
the housing.
STEP 2
Slide the O-ring
along the
battery wires.
STEP 3
Press down on the battery
until the top of the battery is
below the O-ring groove.
Squeeze the O-ring into an
oval shape and push it into
the groove in the battery cup
as shown in the photo.
Do
not grease the O-ring.
STEP 4
Make sure the connector wires are not pinched in any way, especially
between the O-ring and the battery or case. Pinched wires can break
internally and disrupt power to the receiver.
STEP 5
