VEMAG 168.1004, Operating Instructions Manual, Page: 108 / 167

HP10E / HP12E / HP15E / HP20E - Dairy design 6. Graphical control
6-70 © VEMAG 2013
Number Message Cause Remedy
813 Weight/speed limits knife
offset
The value range for input depends
on another parameter and vice
versa.
-
814 input limit reached The value range for input depends
on another parameter and vice
versa.
-
815 Weight/speed limits knife
time
The value range for input depends
on another parameter and vice
versa.
-
816 Weight/knife time limits
speed
The value range for input depends
on another parameter and vice
versa.
-
817 Belt speed too high! The value range for input depends
on another parameter and vice
versa.
-
818 Coextrusion delay too
long!
The value range for input depends
on another parameter and vice
versa.
-
819 Weight limits speed The combination of weight, feed
system, portions per signals and
external signals requires a speed
> 100 %.
Modify settings, check signals
at S-K.
820 Input limit reached The length of the empty casing
is limited to guarantee reliable
conveying.
-
821 Speed limit reached Filling (or belt) speed was limited
by the specified value.
Accept the speed limit or increase
the specified value.
822 Print mark control active With the print mark control feature,
the filling volume is controlled
using print marks on the casing
(with signals to Remote-K). This
message appears when you enter
a weight correction in this mode.
Confirm whether the print marks
on the casing or a preset weight
correction should be used to
control the output weight. Activate
or deactivate the print mark control
application.
823 Poor distance For the print mark control applica-
tion, it is important that the print
mark signal (Remote-K) is given
while one portion is being filled.
Otherwise the message indicates
that the sensor is ill positioned
(distance to clipping area).
Position the sensor so that the
signal (Remote-K) is around the
centre of the portion.
827 Hanging speed exceeded AH 204: the current setting leads
to more than 300 hooks per
minute (= limit value). This value
can only be reached without empty
pins between the hooks.
Find a setting that leads to fewer
hooks per minute.
828 Portion frequency incre-
ased
AH 204: the time between two
hook signals has shortened. The
machine cannot implement this.
The sausage per hook value has
been doubled!
Check if there actually are pro-
blems during hanging. Ignore the
message if there are no pro-
blems. Otherwise, note all version
numbers and program settings
and notify VEMAG Customer
Service.