11
Configuring and setting
To save energy and extend tube life, the unit allows you to blank the display for
certain periods (e.g. at night, while you are absent, etc...) The digits on the left
hand side of the separator indicate the hours (00 to 23).
By pressing the button briefly, you can toggle between ‘show this hour’ and
‘don’t show this hour’, for each hour of the day. Hours advance automatically
every second at button release.
Default the display is blanked between 1 and 6 in the morning. Settings are
stored in eeprom and will be remembered at next power on.
Show this hour
Show this hour
Show this hour
Don’t show this hour
Don’t show this hour
Don’t show this hour
Now you can set the clock. Press and hold the button to advance. After a couple of seconds, the unit advances fast. At release,
seconds start from ‘00’.
Setting the clock when the display is blanked
: If the display was blanked, it will turn on when the time set button is pressed.
At release, the display will stay on for 5s after which it will blank again.
Note:
Separator will be active at all times, also when the display is blanked, to indicate that the high voltage is present.
As there is no AM/PM indicator, during time setting the unit always switches to 24h mode, even if 12h mode was selected.
At release, unit returns to 12h mode.
3
Summary of Contents for K8099
Page 12: ...12 Schematic diagram base Schematic diagram...
Page 13: ...13 Schematic diagram display Schematic diagram...
Page 14: ...14 PCB Main PCB...
Page 15: ...15 PCB Display PCB...
