9
Assembly & test
Cut the pin header at position 17 so that 16
contacts are left over.
Insert the header into the display board
connector.
Assemble both PCB’s using 4 spacers and 8
screws, make sure that the 16 pins come
through the main board holes.
Solder the connector to the main board, and cut
the connector left over.
ASSEMBLY
Connect the 12Vac to the board, if all works well, the displays should light. Check the user manual for further set-up
FINAL TEST
spacers
M3 6mm bolt
! use 16mm bolts if K8099
used with B8099
Summary of Contents for K8099
Page 12: ...12 Schematic diagram base Schematic diagram...
Page 13: ...13 Schematic diagram display Schematic diagram...
Page 14: ...14 PCB Main PCB...
Page 15: ...15 PCB Display PCB...
