CCTVPROM9
23/11/2010
©
Velleman nv
6
Connecting the power supply
•
Plug the DC output connector of the included power adaptor into the 19VDC power input at the back of the
DVR.
WARNING:
only use the included adaptor.
•
Plug the included power cable into the adaptor input connector and plug the other end into the mains.
Do
not
switch the DVR on yet.
Connecting a camera
•
Connect the video output of the camera to either video input at the back of the DVR. Connector type is BNC.
Note:
video system is detected automatically; therefore it is important that the cameras are power-supplied
before
the DVR is powered-on.
Connecting audio
•
The
DVR
supports one audio input. Connect the audio output of an audio source to the audio input of the
DVR. Connector type is RCA.
•
There is also an audio output connector. Connect an audio device e.g. a speaker to this connector when
desired. Connector type is RCA.
Connecting Local Area Network (LAN)
•
Connect the DVR to a local network by plugging a network cable into the LAN port at the back of the DVR.
Connector type is 8P8C (RJ45). Setup is done through the OSD.
7.
Preliminary settings
•
Make sure the connected cameras are on and set the power switch at the rear of the device to the on-
position. It takes about 15 to 30 seconds to start up.
Menu overview
•
Press the MENU button and enter the password to go into the menu list.
Note
: default admin password is “
0000
” (4 times zero).
For more details, refer to the full user manual.
Setting date and time
•
Before using the DVR the time and date should be set to get a valid time stamp.
•
Press the MENU button and enter the admin password to go into the menu list.
•
Select the QUICK START menu item with the
S
,
T
,
e
or
f
buttons.
•
Move to the TIME SETUP menu item. Select it to set date and time.
Note:
once recording started, do not change date or time as this will make it very difficult to find back the
recorded files.
Note:
when using the DVR for the first time and the correct time is set, leave it on for at least 48 hours.
Password setting
•
Press the MENU button and enter the password to go into the menu list.
•
Select the SYSTEM menu item.
•
Go to TOOLS, select ADMIN PASSWORD (or OPERATOR PASSWORD) and press the ENTER button to set the
password.
Note:
an operator can not access the main menu, only the quick menu bar (see below).
•
Press the cursor up (
S
) or down (
T
) button to select the value of the first number and press enter to save
and go to the next character, or use the mouse to select the desired value. Repeat this for all four password
numbers.
Note
: default admin password is “
0000
” (4 times zero).
Record settings
•
Press the MENU button and enter the password to go into the menu list.
•
Select the QUICK START menu item using the
S
,
T
,
e
or
f
buttons.
•
Select the GENERAL menu item.
•
Set the image quality and images per second for recording.
•
Refer to the full user manual on the included CD-ROM for more details.
Audio playback
•
Press the SLOW and ZOOM button simultaneously to select the desired audio channel or use the quick menu
bar (see below). The current audio channel is indicated in the status bar.
User profile selection
•
It is possible to log on to the system as administrator ( ) or regular user ( ). An icon is shown in the
status bar.
•
Switch between user profiles by clicking on the icon ( or ). The lock-icon ( ) is now displayed.
•
Click on the lock-icon and enter the password of the desired user profile.
8.
Operation
Display
The following image shows the screen layout.
