CAMSETW1
4
VELLEMAN
Example of the auto sequence function :
If you have 2 wireless cameras and you wish to view the picture of channels 1 & 3 on the monitor, you should place
DIP switches 1 & 3 in the ON position. Put DIP switch 5 in the ON position if you want to switch cameras every 8
seconds. Leave DIP switch 5 in the OFF position if you want to switch channels every 4 seconds.
Put DIP switch 1 or 3 in the OFF position if you want to display the picture of 1 camera continuously.
8. Troubleshooting
There is no signal :
•
Check the ON/OFF switches of the camera and the monitor.
•
Make sure the power plugs are pushed all the way in.
•
Make sure the same channel is selected on the camera and the monitor.
•
If the camera and/or the monitor are battery-powered: check if the batteries need to be replaced.
•
If you have no picture or a poor one: check the SCREEN ON/OFF button on the front panel, or adjust the V-
HOLD/CONTRAST/BRIGHTNESS button at the back of the monitor.
You're getting a weak signal or there is interference :
•
Reorient the antennas.
•
Set the same channel for the camera and the monitor.
•
Make sure there is no microwave between the camera and the monitor. If so, deactivate it or move it.
•
Do not exceed the max. distance of ± 100m between the camera and the monitor.
•
Check the setting of the monitor's DIP switches.
9. Maintenance
•
Only reorient the antennas if the picture quality is unsatisfactory.
•
Keep this device away from children.
•
Fingerprints or smudges on the lens can affect picture quality. Do not touch the lens with your fingers.
•
Keep the device dry. Water contains minerals that corrode electronic circuits.
•
Do not store this device in a dusty or dirty environment to avoid damage to the moving parts.
•
Do not store the device in a warm location. High temperatures shorten the life of electronic devices and plastic will
melt.
•
Do not store the device in a cold environment. Condensation may form inside the housing when the device is
subsequently moved to a warmer environment.
•
Do not try to open the housing. Have the device repaired or serviced by a schooled technician.
•
Do not drop the
CAMSETW1
, do not shake it or hit it. Rough handling may damage circuit boards.
•
Wipe the device clean with a soft cloth and a mild detergent. Do not use solvents or abrasives.
•
Only use the supplied adapters.
•
Do not overload the used outlets and extension cords to avoid all risks of electroshocks and fire.
