20
CAMERA ID : 001
BAUD RATE : 2400 BPS
WAITING………
PAN ORIGIN TEST OK
TILT ORIGIN TEST OK
TX CONNECTION
TEST OK
CAMERA COMM TEST OK
Veilux Model # VP-58CND12X User Manual
DIAGNOSTIC
Whenever the dome is powered on, a standard diagnostic is operated.
The following messages are displayed on the monitor.
A.
Pan Origin Test
Zero point of Pan is located during the Panning test.
B.
Tilt Origin Test
Zero point of Tilt is located during the Tilt test.
C.
TX connection Test
The TX connection test looks for commands from a controller to the dome. If no commands are
detected the test will exit after 60 seconds.
During the 60 seconds, the camera must receive a signal from the controller or DVR, so please
operate the controller during this phase. As soon as the dome detects a command “OK” will be
displayed and the test will move on to the next step.
If the Tx connection test fails check the RS 485 wiring.
D.
Camera Comm. Test
Camera communication is also checked.
OK should be displayed in these four tests before installation.
If all the above Tests are OK,
“NOW EEPROM CHECKING”
and
“ALL DATA INITIALIZING”
is dis-
played and the camera is ready to operate.
Website:
www.Veilux.net
Phone # 1-800-510-6528
