Vega Ketron, Owner'S Manual

Page: 74 / 122

VEGA
73
U tility
The Utility menus are used to control the physical controllers, the MIDI accordions, the pedals
and a group of parameters that modify the general performance of the VEGA.
From the main page of the display, press
F3 Utility to access the first page indicated as 1/2 at the top right part of the display. To select the
other page use the PAGE +/- push buttons. The single groups of parameters, to which other menus correspond, are enabled using the relative
function push buttons.
UTILITY - PAGE 1/2
F1 Accordion: This calls up a new page with the parameters dedicated to the use of a MIDI accordion. For further details, please refer
to the chapter ‘MIDI Accordion’ below.
F2 Modulation:
This calls up a new menu dedicated to the management of the Modulation Wheel. The parameters available are the
following:
F1 LFO Pitch: When On , the Modulation Wheel controls the entry of the modulation of the LFO on the pitch to create
a cyclic vibrator. It can be set Off only if at least one modulation between DCF, DCA, Cutoff and WhaWha is enabled so
that the Modulation Wheel always controls a parameter.
F2 LFO DCF : When On , the Modulation Wheel controls the entry of the modulation on the LFO on the filter cut-off.
F3 LFO DCA: When On , the Modulation Wheel controls the entry of the modulation on the LFO on the amplitude to cre-
ate a cyclic tremolo.
F4 Cutoff: When On , the Modulation Wheel directly controls the filter cut-off. This proves useful to control the har-
monic richness of a timbre. It cannot be used if F6 Wha-Wha is already enabled.
F5 Escape: This returns to the initial page of the Utility menu.
F6 Wha-Wha: When On , the Modulation Wheel controls the Wha-Wha effect, typical of electric guitars. It cannot be
used if F4 Cutoff is already enabled.
F7 To Swell: When On , it transfers all the parameters controlled by the Modulation Wheel to the optional Volume pedal.
F8 Mod. Rate: The value entered using the VALUE +/- push buttons defines the velocity of the LFO’s used with the
Modulation Wheel
F9 Mod. Amou: The value entered using the VALUE +/- push buttons establishes the modulation depth that can be
obtained using the Modulation Wheel for the LFOs.
Utility