Vega MT-5 CAN / User Manual
16
Revision № 04 of 01 July 2022
SWITCHING INPUTS CAN/RS-485
GNSS tracker MT-5 version 2 with CAN-bus support by default uses
To use inputs 4 and 8 as RS-485 interface you need to connect to the device through the
“Configurator” program and go to the “Settings” menu -> “Inputs/Outputs” tab.
Find the settings item "Additional interface settings" and check the box "Use CAN as RS-485".
FUEL LEVEL SENSORS
GNSS tracker allows you to connect fuel level sensors via the RS-485 bus and operates with them
using the LLS protocol.
To do this, you need to connect to the device through the “Configurator” program and go to the
“Settings” menu -> “Inputs/Outputs” tab. For each connected fuel level sensor, it is necessary to select “Sensor
Type” - RS-485 and specify the sensor address on the bus in the “Bus Address” field. The specified address
must match the address specified when the sensor programming (see instructions for the used sensor).
Up to four fuel level sensors can be connected simultaneously.
