The most common Ethernet Frame format, Type II
MAC, VLAN, MPLS, IP, UDP, eCPRI, DATA, and RX Filter Test Pattern Configurations:
To configure the MAC addresses, IP addresses, VLAN tag(s), and test pattern, tap on the frame image displayed on the screen.
This brings up the configuration screens for all the header fields.
Tap the
Apply
button at the bottom to save your selections to the current stream or
Apply to All
to save your selections to all
streams.
MAC Header Tab:
MAC Source:
Use the default source address of the test set or configure a new or different address.
Tap the
Mac Source
button at the bottom to populate the fields with default test port settings.
For Layer 4 (IPv6) only: Tap the NDP Gateway and NDP buttons at the bottom to locate MAC addresses on the local
network for the network address designated in the gateway.
MAC Destination
: Configure the destination MAC address of the far-end partner test set.
Ethernet Type:
Layer 2:
AE-FE (fixed)
Layer 4
: Set to 0800-IP (fixed), or
select 8847-MPLS unicast or 8848-MPLS multicast if MPLS tagging is enabled.
Throughput Setup - MAC Layer 4
eCPRI Testing User Manual D07-00-131P RevA00
Page 21 of 53
Summary of Contents for eCPRI
Page 1: ......
