6.3 eCPRI Setup
Test mode, test port(s), and network settings are required prior to performing any measurements or applications.
6.3.1 Test Port Selection
Test Mode Selection
This menu is accessed via the Test Port button located at the top left hand side of the screen.
To select the eCPRI test:
1. Click the
SFP28/SFP+
Test Port, and then select the
eCPRI
test mode.
2. Select the test interface type (10G, 25G, or 25G with RS-FEC), and then click
OK
.
6.3.2 Port Setup
Configure the Test Ports and/or Test Interfaces using the Setup menu on the Home page. The available configuration settings
depend on the interface selected.
Select the operation mode and the interfaces that will be used to carry out tests. Once the operating mode and interfaces are
selected, the the auto-negotiation, speed, duplex, and flow control settings for each port (where applicable) can be configured.
The figure below shows a 10G Port Setup.
eCPRI Testing User Manual D07-00-131P RevA00
Page 15 of 53
Summary of Contents for eCPRI
Page 1: ......
