Vdwall LVP909 Series, User Manual, Page: 20 / 35

105 106
D.3 Output Image ( Image 1 ) AppM1 M1
D.3.1 Out Width 640
D.3.2 Out Height 320
D.3.3 Out H_Start 16
D.3.4 Out V_Start 16
D.3.5 In Width 1920
D.3.6 In Height 1080
D.3.7 In H_Start 0
D.3.8 In H_Start 0
2. PIP output image setting
D.3 Output image is used to set PIP output image parameters. Setting method:
M2 , M3 , M4 ) to switch display modes and press ↑ or ↓ to select corresponding
output parameters. Rotate knob to adjust parameters and press OK to save.
Pic 7-8b LCD window: PIP output image setting
1. Switch image source
D.1 Image_1 source and D.2 Image_2 source is used to switch image source.
Setting method
：
Enter setup menu D. PIP , press display mode buttons ( M1 , M2 , M3 , M4
)
to switch display modes. Then press ↑ or ↓ to select corresponding image source
and rotate knob to select input signal and press OK to save.
Enter setup menu D.3 Output image PIP, press display mode buttons ( M1 ,
LVP909 opens RS232 control protocol, supporting remote control by PC, Android
or iOS and other intelligent terminals. As below we illustrate the hardware connection
and relative software operation.
Chapter 8 Remote control instructions
RS232 is the most common remote control port. When use RS232, we only need
to use an RS232 cable to connect PC to processor’s RS232 port, then we can use
software to remote control processor. When PC does not have RS232 port, USB
control method can be used.
8-1 Hardware communication
The remote control ports of LVP909 include RS232, USB and wired network control.
We will illustrate the hardware communication connection and setting.
3 2 1
1 : RS232
2 : USB
3 : LAN
Pic 8
-
1a LVP909 remote control ports
1 RS232 and USB
.
Pic 8-1b PC connection by USB
/
RS232
PC LVP909
RS232 or USB
LVP909 Series User Manual LVP909 User Manual Series