■
Audible settings.
Settings for the audible guidance messages:
❑
SDVC:
Adjustment for speed-dependent volume increase.
Small (1) to large (5) increase in volume on acceleration. For “0” there is no
increase.
❑
Volume:
Setting of the volume for the guidance messages.
❑
Voice on/off:
Activates/deactivates the audible guidance messages.
✎
With the audible announcements switched off, the
l
symbol flashes in the bottom
status line.
☞
Store the modified settings using “Return”.
☞
Press the
ESC
or the
4
button to exit the menu without changes.
■
Measuring units
Setting of Time format and Date format, measuring units for distance specifications
and adjustment of the current Time zone.
☞
Store the modified settings using “Return”.
☞
Press the
ESC
or the
4
button to exit the menu without changes.
■
Device config.
The device configuration contains the connection settings which have to be carried
out once when the system is installed and/or in the case of subsequent system
upgrades.
☞
Activate the corresponding addition.
☞
Store the modified settings using “Return”.
☞
Press the
ESC
or the
4
button to exit the menu without changes.
■
Shut-down timer
Setting of the shutdown delay time for the navigation computer (sensible e.g. for
short intermediate stops). The current planned route remains stored, the navigation
computer is immediately ready for use after switching off the ignition without any
start-up phase.
Set the desired shutdown delay time to between 1 ... 10 minutes.
☞
Store the modified settings using “Return”.
☞
Press the
ESC
or the
4
button to exit the menu without changes.
✎
The device will shut down completely after the set time.
System information
The following options are available in the “System information” menu:
❑
Diagnosis:
Code-protected menu for installation and service purposes.
❑
Default settings:
Resets the user-specific settings to the factory values.
✎
An overview of the default settings can be found in the appendix on page 41.
❑
Configuration:
Display of unit identification and hardware and software versions for
service purposes.
❑
Speed correction:
The navigation system uses an average cruising speed to calculate
the remaining travel time and the estimated time of arrival. If required, you can
adapt this speed to your actual average speed. However, we do not recommend
you deviate significantly from the standard value of 100%.
Settings
36