Step 4: Follow Your Route
Follow the route to your destination using the Map page. As you travel, your c330 guides you to your destination with voice
prompts, arrows on the map, and directions at the top of the Map page. If you depart from the original route, your c330 voice
announces that you are off-route and then provides new route instructions.
Your route is marked with
a red line.
Follow the arrows as you
take turns.
A checkered flag marks
your destination.
Read the driving
instructions at the
top of the page.
Step 2: Configure Your c330
The first time you turn on the unit, follow the on-screen instructions to set up your c330. You only have to do this once.
Step 3: Find Your Destination
Touch
Where to?
Select a category.
Touch the arrows to see
more categories.
Select a destination.
Touch the arrows to see
more places.
Touch .
Enjoy the route!
StreetPilot
®
c330
quick reference guide
WARNING
: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the c330 installed to place and secure the device so it will not interfere with the vehicle operating controls and
safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an accident.
NOTICE TO STATE OF CALIFORNIA DRIVERS:
California Vehicle Code Section 26708 (a) (1) provides that drivers in California should not use suction mounts on their windshield or side or rear windows.
Other Garmin dashboard or friction mounting options should be used. For available accessories, refer to the Garmin Web site at www.garmin.com. Also, refer to the
Owner’s Manual
for instructions on using the
included mounting disk with the suction cup mount.
Step 1: Mount Your c330
Place the suction cup on your
windshield.
Fit the bottom of your c330 into
the cradle of the suction cup
mount.
Tilt your c330 back until it
snaps in place.
Flip the lever back, toward
the windshield.
Tension knob
To ensure a tight grip, clean and dry your windshield before you mount the suction cup. Plug the cable into a receptacle in
your vehicle. If necessary, use the tension knob to loosen or tighten the tension in the mount to improve your viewing angle.
Your unit will turn on automatically if you have started your vehicle. To manually turn on your c330, press and hold the
Power button
on the side of the unit. Refer to the image on the back of this sheet.
