5
* Depending on version
BEFORE YOU START....
Thank you for purchasing this VDO Dayton
product which has been designed and
manufactured to the highest standards and
subjected to rigorous testing.
Kindly familiarise yourself with the product by
reading this user manual. Keep this manual handy
in your car for future reference.
ENVIRONMENT
This booklet is printed on low-chlorine recyclable
paper.
IMPORTANT
This device has been designed and produced
according to applicable Safety Regulations.
Please read carefully the instruction manual and
use the device as intended.
CONTENTS PAGE
INSTALLATION ................................................ 5
PREPARATION ................................................ 5
MOUNTING ..................................................... 6
FRONT PANEL PRESENTATION ................... 7
SECURITY ....................................................... 7
AUDIO .............................................................. 8
RADIO .............................................................. 8
RADIO DATA SYSTEM (RDS) ON FM ........... 9
CASSETTE PLAYER ........................................ 9
CD PLAYER .................................................... 10
SPECIAL FUNCTIONS .................................. 10
SAM (Software Access Mode) ...................... 11
TROUBLE SHOOTING ................................. 13
Complies with 21 CFR 1040.10
INSTALLATION
If your car is equipped with ISO connectors,
simply insert them in the connectors of the car
radio. If not, you can use an adaptor cable (Refer
to the table on the separate installation manual).
Ensure all cables are installed so that they cannot
be damaged by sharp edges or moving parts.
PREPARATION
Voltage and polarity:
The set must be connected
to a 12V car battery with negative terminal to
earth (car chassis). Installation in vehicles not
fulfilling these requirements could result in
malfunction, damage or fire.
Warning:
To prevent shor t-circuiting,
disconnect the negative car battery terminal
until the set has been mounted and
connected (fig.1 See separate installation
card).
CONNECTOR A (fig.2)
Power supply connections
•
Red wire A7 :
Connect to a permanent 12V
supply. This is the main power supply. Ensure
this connection can handle a current of 10A.
•
Yellow/red wire A4 :
Connect to a switched
12V supply (switched on/off by car ignition).
•
Brown wire A8:
Connect to earth (car chassis).
•
Electronic antenna/Motorised antenna
:
Connect pin A5 to the power supply for an
electronic antenna or the control wire for the
replay of an antomatic motorised antenna. Use
the small connector supplied.
Do not use this connection for the supply
lead of the aerial motor!
•
Pilot light
:
When the car headlights are switched on, the
backlight to the power key remains illuminated
(even when the radio is switched off).
Connect pin A6 to the dashboard illumination
wiring of the car. Use the small connector
provided.
01-2102.p65
15/04/2001, 3:49 PM
5
