5
operation / accessories
4. How to Operate
1.
Plug the cord into an electrical outlet and turn on by
pressing the on/off pedal, located on the back left of the
cleaner (1).
To unlock the handle from the upright position press the
handle release pedal (2) down.
Move the handle to the desired position (a) for storage and
position (b) for normal operation. To clean under furniture,
press the release pedal again and use position (c) (Fig.4/1).
5. Accessories
NOTE: This unit is fitted with a constantly rotating
brushbar. To avoid damage to your carpet, ensure the
unit is not left on the stair tread when using the
accessories.
1.
Make sure the vacuum cleaner has been switched off
and is in an upright position. Remove the lower hose by
twisting clockwise and pulling away from the base of the
cleaner.
Remove the hose from the tool holder.
Slide the hose into the lower hose with the tab facing
upwards twist together to secure (Fig.5/1).
2.
For hard to reach areas when additional hose length is
required, use the extension wand. It fits over the end of
the hose handle.
Choose the accessory that suits your need or use the hose
alone.
To fit the attachments push them firmly on to the end of
the extension wand or hose handle. To remove the tool,
twist and pull apart gently.
When moving from one room to another use the carrying
handle at the rear of the vacuum cleaner (Fig.5/2).
b
c
a
1
2
Fig.4/1
Fig.5/1
Fig.5/2
.
WARNING:
This cleaner has a constantly
rotating brushbar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE:
Vax recommends that you raise the height of
the brushbar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.
!
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
U89-AS Series User Guide:VS-190 User Guide 18/03/2011 14:39 Page 5
