7
belt & brush replacement / clearing blockages
7. Belt and Brush:
Removal and Replacement
1.
Unplug the vacuum cleaner from the mains supply.
Press the handle release button and turn the vacuum
cleaner over so that the base lies flat and face up. Use a
screwdriver to remove the four retaining screws shown
above. Remove the nozzle guard.
Lift and remove the brushbar, then slide the belt off the
motor shaft and dispose of it. Place a new belt on the
motor shaft and then slip the brushbar through the belt.
The belt should sit on the section of the brushbar without
bristles. Re-fit the brushbar. Ensure the end caps are in the
correct position. Rotate the brushbar to check the belt is
not twisted. Replace the nozzle guard (Fig.7/1).
8. Clearing Blockages
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing
.
Clearing Blockages from the TurboTool
(Some models only)
1. Turn the TurboTool over and slide off the locking ring
(Fig.8/1).
2. Pivot lowering housing and remove clog (Fig.8/2).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the locking ring into the
groove at the neck of the TurboTool to complete
reassumbly (Fig.8/3).
Fig.7/1
!
Fig.8/1
Fig.8/2
TABS
Fig.8/3
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
U89-AS Series User Guide:VS-190 User Guide 18/03/2011 14:39 Page 7
