Vauni Edge, Manual

Page: 29 / 56

© Copyright 2020 Vauni AB - All rights reserved Vauni Edge / Shadow
| 29
ENG
ENG
Then the burner is fully tanked, which corresponds to 1,8 liters of bioalcohol.
Note! For safety reasons the fuel transfer occurs with some delay. To avoid over-filling the burner, it is
important to give the fuel time to settle downward. Be especially careful, therefore, during the last part of
the filling. Let the bottle drip a little over the opening before removing it.
4. Be careful to avoid all spillage – any spill should be wiped off with a piece of paper. If overfilling occurs,
use suitable utensils to remove excess fuel, so that the fuel comes level with the burner strainer. The liner
is sensitive to fuel spillage. It is therefore important that the filling is done carefully, and that a dry rag or
paper is used to wipe off the bottle immediately after filling. If spillage does occur despite this, it should be
wiped off immediately, since dried fuel can cause permanent spots.
4.2.3 Handling of spillage
Avoid all spillage as far as possible. Take good time when refilling. If an accident does occur, observe the
following.
Note! Large amounts of spillage are caught by a built-in spillage tray. If this has happened, it is very important
to carry out the following restoration procedure – do not light the fireplace before then!
1. Immediately wipe off the liner with a dry rag to avoid discolouring.
2. Take out the burner module.
3. Wipe up the collected fuel with a rag or the like. See that the whole space is completely cleaned.
4. Lower the burner module by following instructions in section 3.1 Assembly and installation, step 12. See
that the regulator lid is positioned correctly.
19 21 20
max 1
mm