Vauni Edge, Manual

Page: 33 / 56

© Copyright 2020 Vauni AB - All rights reserved Vauni Edge / Shadow
| 33
ENG
ENG
the regulator lid should lie closely against the burner’s surface and slide easily when the regulator rod
(which grips in the holes provided in the regulator lid) moves it to its respective stop.
7 FAULT FINDING
The fireplace cannot be lit
Possible causes:
• No fuel is in the burner module.
• The fuel level is too low.
• The burner’s safety system makes it hard to start.
• The fuel being used is incorrect or has been diluted by excess cleaning liquid or the like.
• The regulator lid is not fully open.
Measures:
• Add fuel.
• Start the burner according to the instruction in Section 4.1 point 4.
• Change the fuel. See Section 4.2.1 for recommendations.
• Move the regulator lid toward the fireplace’s opening until it stops. If the burner opening is not fully
exposed, see the assembly instructions to position it correctly. If this does not help, contact the place of
purchase for the nearest service technician.
The fireplace starts but goes out again
Possible causes:
• Low fuel level.
• The regulator lid is not fully open.
• The burner’s safety system makes it hard to start.
Measures:
• Repeat the starting procedure.
• Add fuel.
• Start the burner according to the instruction in Section 4.1 point 4.
• Move the regulator lid toward the fireplace’s opening until it stops. If the burner opening is not fully
exposed, see the assembly instructions to position it correctly. If this does not help, contact the place of
purchase for the nearest service technician.
The flame is unstable or unusually large, or leans toward one side, or forms a strong vortex (whirl)
Possible causes:
• The flame is exposed to a draught.
• The fireplace is leaning
• The wrong type of fuel is being used.
Measures: