Vatech EzRay Air W, Installation Manual

Page: 7 / 68

Conventions Used in this Guide
EzRay Air W (VEX-S300W) Installation Manual vii
Failure to read and understand the information provided in this
manual may result in physical injury, damage to the equipment or
equipment failure. Please read each chapter in its entirety and
understand the information therein before attempting any of the
installation procedures.

It is critical that installers read and understand the installation
instructions fully before installation.

The installer must confirm that the system is installed
according to the instructions provided by this manual and
perform the appropriate procedures therein.

If the equipment has been stored at temperatures of below
10
℃
(50
℉
) for more than a couple of hours, allow the
equipment to reach room temperature before applying mains
voltage.

Installation and related work must only be performed by
people authorized by VATECH.

Do not connect any items or equipment to this system which
are not part of the system: IEC60601-1-1 .

Any equipment not approved by VATECH must comply with
the applicable standards: IEC 60950-1 for IT equipment (Ex:
PC) and
IEC 60601-1
for medical electrical equipment.

All operators of this equipment are responsible for ensuring
that the requirements outlined in
IEC 60601-1-1
: Safety
Requirements for Medical Electrical Equipment are fully met
to ensure the safety of patients, operators and the
environment.

Use an ESD (electrostatic sensitive device) wrist band during
installation and connect it to a ground wire.

Touch a ground point to discharge static electricity before
handling PCB boards