Doc. # 01
-
04
-
033A
Note:
It is important to wear dark shaded and UV rated
eye protection while testing any UV Lights.
Do Not allow objects to contact the UV lights.
1)
Inspection of UV Black Bulbs. Lift the lid
and override the safety switch on the
left side of the cabinet by depressing
with your finger or a pencil. Put your
sunglasses on and hit RUN from the
setup screen. With the lid up view if ALL
lights are working. If not, proceed to
step 2. Contact factory for replacement
lights.
Troubleshooting Cont’d
UV Black Light Bulb Replacement / Installation
2)
Unplug main power cord.
3)
Remove exposing unit glass, see
Maintenance section for glass removal.
4)
Open the maintenance door in the front
of the unit by removing the (4) #8 sheet
metal screws with a 1/4” driver.
5)
Turn Bulb 1/4 turn and lift straight up to
remove.
6)
Install new bulb by placing the bulb in
position, and lightly turning bulb 1/4 turn
until bulb pins are seated.
7)
Test the new bulb. See above section 1.
8)
Close the maintenance door and
replace the #8 sheet metal screws.
Maintenance door
Step 4
Depress Limit
Switch when
testing lights
Step 1
Pg. 12
