PAGE 22
Slicing Settings Explained
Resolution
Change resolution settings. Choose from 300, 200, 100, and 50 micron. Default set to
Medium - 200 (0.2mm per layer). Printing at a lower resolution (300 micron) will allow for a
faster print, while printing at higher resolutions (50 micron) will take the longest, but allow for the
best finish.
Filament
Input the diameter of your filament. Use of a digital caliper is recommended. If you are using
Trifecta PLA filament and do not have a caliper on hand, set to 1.75 mm.
Infill
The infill setting adjusts the model’s density, default is set to 10%.
From left to right: 0% Infill, 10% Infill, 20% Infill
Wall
Changes the thickness of the wall that make up the outer surface of the model. Default is set
at 2.
From left to right: 1 Wall, 2 Wall, 3 Wall.
